New Page 1

If you would like a complete technical specification, application and schematic report, it is available through here : Download the adobe pdf file

You will need the FREE "Adobe Acrobat Reader" to view the information which can be obtained from Adobe at the following address: http://www.adobe.com

This Control Units Highlights

Underwriter's Laboratory and Underwriter's Canada Listed (File E183233). Respected throughout the United States and Canadian Provinces.

Adjustable Ramp provides a Soft-Start for the feeder bowl or inline linear track to cycle on gently. A ramped 'On-Cycle' keeps piece parts from falling off the tooling when starting. In addition, the tooling, drive mechanism, and drive springs are shocked less with each 'On' cycle

Run Interlock Input allows the control to be cycled on and off via several inputs: a) a 5 - 30VDC or 105 - 250VAC interlock signal from a part-sensing feeder control or from a customer's PLC. b) a hopper paddle switch or a low current relay contact closure, switching a 5VDC, 2mA signal.

A Maximum-Output Limiting Adjustment allows you to preset the maximum output of the main control pot. By limiting the 'Full ON' output, a machine operator cannot turn the main pot up too high. This feature can prevent destructive 'Hammering' of the drive coils, tooling cracks, and spring breakage.

A Special Logarithmic-tapered Power Output Curve is controlled by the main control potentiometer. This spreads the power curve broadly across the main pot dial helping give maximum "Fine Control" over the bowl's output speed. No more 'touchy settings' or 'tight' bands of control.

Models are available for either 120VAC or 240VAC operation and the controls will operate on either 50Hz or 60Hz line frequency.

Full Wave/Half Wave Output is Switch Selectable from 120 pulses per second (un-rectified) to 60 pulses per second (rectified).